Diagnosing Power Supply Problems
The most obvious symptoms of a failed power supply occur when you turn your computer on and hear a loud noise, smell something burning, and/or see smoke, and the computer won’t power on. Shut off the power immediately; you likely have a blown power supply. If there is smoke, you’ll want to ventilate the roomit is toxic. Usually, както и да е, the symptoms of a blown power supply aren’t nearly so dramatic; you turn on the computer and nothing happens.
Always Check the Voltage Switch!
We’ve said it before and we’ll say it again: Make sure the power supply is set for the correct voltage.
Unusual Noises
If you hear a grinding noise, or there is excessive vibration, the power supply fan might be going bad. Visually check the rotation of the fan. Don’t try to replace the fan, replace the power supply. A loud hum that changes pitch while you’re doing different things usually indicates a bad power supply.
Testing the Power Supply
Testing a power supply is straightforward. Antec (Antec-inc.com) offers a simple, inexpensive ATX power supply tester, although it is helpful to have a voltmeter or multitester to use with it. Simply connect the tester to the power connector and view the LED. If green, the power supply is working. For a better reading, while the tester is in place, touch a voltmeter’s or multimeter’s probes to the tester’s leads to read the voltage. Voltage should be 12v, 5v, or 3.3v, depending on the connector. Tested voltage should be very close to the rated number.
Removal and Replacement
This is usually straightforward. Make sure the power cord is disconnected. With most tower or desktop case, you’ll have to open the case and remove the screws from the back around the power supply. Because some manufacturers have special connectors attached to the motherboard and other devices inside the system, you should draw a diagram of the colors of the wires and positions of the connectors as you are disconnecting them so you can match the power supply and connect it or a new one properly. Then, remove all of the power connectors. The power supply should then come right out. In some computers, the power supply is mounted to a bracket. You’ll have to remove the power supply from the bracket. Replacing the power supply, or installing a new one is done the same way, in reverse.
Note For a useful discussion on PC power supplies, go to http://computer.howstuffworks.com/power-supply.htm.
към : Книга-компютър ремонт и поддръжка: А Практическо ръководство











































